recently purchased an alpine cda 9887 along with the alpine amp ktp 445 head unit power pack, improvement is incredible, did not want to go through running an external amp and the the wiring which would be needed with it. no problems with plug and play issue. my question is the following can i run 2 ohm infinity speakers with this setup or should i purchase 4 ohm speakers. thanks for the help greatly appreciated
-
1Participant count
-
Participant list
Activity
No one is currently typing a reply...
Similar threads
Directly into the amp with this. Bypass the RCA's in use to isolate the source of the noise. Turn the car on, plug this directly into the amp from...
- Started by 97obs
- Wiring, Electrical & Installation
This is what you need-
- Started by cdreece
- Wiring, Electrical & Installation
If the JBLs have tweeters built in, disconnect two of the tweeters and the 4 Ohm tweeters will be their replacement. Then connect one combo on the...
- Started by 07FLSTC
- Speakers
Out of the amps you mentioned
Kenwood 805 hands down best bang for the buck.
You won't be able to tell any difference from 5x7 to 6.5. You may...
- Started by Slayer16102
- Speakers
I really appreciate your advice. You explained it well.
- Started by 6r33n3y3z
- General Car Audio
About this thread
New threads
-
Pionner AVH-P3350BT, remote does not work (blue-white)Tengo una radio pioneer AVH-P3350BT, pero el control remoto...- Started by pedro carbet
- Replies: 1
-
AI Subwoofer enclosure designerHi everyone, I made a custom GPT on OpenAI, just search for...
- Started by BoomBoomBoxBuilder
- Replies: 1
-
Whining noise in SpeakersI have a 1997 Chevy C1500 OBS. Currently running Alpine...
- Started by 97obs
- Replies: 3
-
Vintage Lanzar 12 inchHi Has anyone got the data sheet for an old Lanzar sub? I...
- Started by Mmatt
- Replies: 0
-
