So I have some old 10 inch kicker c10a 8ohm speakers from back in the 90s when they were stillwater designs. I have been racking my brain on what amp I should get to power these sub woofers. I have 3 of them and they run at 150rms 300watt peak at 8ohm and they are single voice coil. Thank you in advance!
-
3Participant count
-
Participant list
- Thread Starter
- #3
Well I mean I dont want to spend a arm and a leg, but I dont want to cheep out either something within the 300 ranget willing to go some over
personally i"d be looking at a infinity k600 or a k1000 and enjoy the headroom. Or the JBL versions (gtr) if not needing a subsonic filter, A rf amp on the more expensive side mini t750 or a p1000 but there are a lot of good choices ya just don't want to buy junk...
Activity
No one is currently typing a reply...
Similar threads
Mine were as short as possible and still I had issues routing them cleanly
- Started by kanihoncho
- Wiring, Electrical & Installation
I agree with every one above. OFC is much better. Copper is a much better conductor than aluminum.
- Started by kanihoncho
- Wiring, Electrical & Installation
Pretty much. It's just a nice kit.
A solo rite Scarlett 2i2, XLR mic and a loop back cable are my next purchases so I can get accurate phase...
- Started by JoeMama541
- Amplifiers
One or two, they are still subwoofer outs and are mono summed signals from both left and right. Even the 2 RCA subwoofer pre-outs on the 2nd one...
- Started by kanihoncho
- Speakers
Speaker ratings are generally a thermal/mechanical limitation of the drivers. Music is dynamic, not continuous. During quiet periods a song, you...
- Started by kanihoncho
- Speakers
