what amp to get

  • 4
    Participant count
  • Participant list

blakwng007

Junior Member
hey wuts up. I just bough two 12" power acoustik subs. I don't know what amp to get. I would like to buy just one amp that is good enough to power both the subs. My price range is under $350

Here are the specs:

1800 watts power handling

700 Watts RMS

2” ASV voice coil

SPL 91 dB

Fs: 33.5 Hz

Dual 4 ohm voice coil

Thanx

 
a mono amp id perfect for multiple subs but i don't think that tsunami is 1-ohm stable and is only 900watts rms at 4 ohms so you could look into the hifonics brutus 1500 which is 1500 watts rms at 1 ohm

 
But of course //content.invisioncic.com/y282845/emoticons/smile.gif.1ebc41e1811405b213edfc4622c41e27.gif Either you hook em up in series or in parallel depending on what OHM rating you want. (effects rms)

 
Activity
No one is currently typing a reply...
Old Thread: Please note, there have been no replies in this thread for over 3 years!
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.

Similar threads

Subs play to the beat with gain low but if I turn it up my subs play loud unwanted never ending bass that is constant and wont stop until I turn...
0
29
You have a blown cap in the amp more than likely. Had the same thing happen to a soundstream amp.
1
42
Getting a good voltage reading does not mean good power transfer. You could read 13.8v out of a 24 AWG wire. Recheck your amplifier's ground and...
2
230
No need to bypass the amp. Most use an LOC that takes the full amped signal and turns it into a flat RCA level signal. Here is the newest I have...
2
432

About this thread

blakwng007

Junior Member
Thread starter
blakwng007
Joined
Location
Baltimore, MD
Start date
Participants
Who Replied
Replies
4
Views
466
Last reply date
Last reply from
bchickens
445981256_3731324230470906_9081536917273579948_n.jpg

Decebal

    Jun 10, 2024
  • 0
  • 0
445387485_1610561083127261_6762343569694877677_n.jpg

Decebal

    Jun 10, 2024
  • 0
  • 0

New threads

Top