what amp for powerbass sub

Hifonics Hercules Gen XX. //content.invisioncic.com/y282845/emoticons/wink.gif.608e3ea05f1a9f98611af0861652f8fb.gif

I had one hooked up to a single 15" PBX and it slammed.

 
currently i'm running two off a us amp 2000x.. not bad results. (cough) 147.. any how i plan on trading my 2000x for a 2000 and eventually getting a second one. roughly 650 shipped for one. so its an investment but you wont be disapointed... i've run mine for hours on hand with no over heating

 
Activity
No one is currently typing a reply...
Old Thread: Please note, there have been no replies in this thread for over 3 years!
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.

Similar threads

Getting a good voltage reading does not mean good power transfer. You could read 13.8v out of a 24 AWG wire. Recheck your amplifier's ground and...
2
125
No need to bypass the amp. Most use an LOC that takes the full amped signal and turns it into a flat RCA level signal. Here is the newest I have...
2
324
It would also be easy to add an equalizer to have individual rca inputs for all of the channels. A decent one can be had for less than $40...
6
457
  • Locked
NVX MVPA1 Best tiny amp Installed a bunch, but have one pushing a sealed 12 @ 2ohm in my daily beater Can bump it all day long and barely gets...
4
746
Amp
This tested well on youtube - not familiar with the brand but it is a pretty standard china build house amplifier...
5
543

About this thread

whthatchback

im fukken crazi
Thread starter
whthatchback
Joined
Location
ca
Start date
Participants
Who Replied
Replies
5
Views
626
Last reply date
Last reply from
Randy Savage
20240604_170857.jpg

metalheadjoe

    Jun 5, 2024
  • 0
  • 0
Screenshot_20240605_200209_Adobe Acrobat.jpg

Dylan27

    Jun 5, 2024
  • 0
  • 0

New threads

Top