Using A LOC(line out connector)...help!?

[joem1cha3l 10+ year member]

Hey guys. I currently have a bose system in my vehicle. There are two seperate stock bose amps, one for the subwoofer and one for the speakers. I have bought 2 -10W6V2's and i want to use the stock head unit. Can I do this using a LOC? Would i connect the LOC to the stock subwoofer wires and then just disconnect the end of the wires from the stock sub (If i dont want to use the stock blose sub?) Also, with a LOC, I assume a seperate power cord is used? WHat about a remote?

Click to read more...

 

[benzmansl65amg 10+ year member]

that would work

 

[benzmansl65amg 10+ year member]

Tap into the sub leads for signal. Run power and ground and you need to get remote

 

[joem1cha3l 10+ year member]

how would i connect the 4 wires though to the sub? If there is two wires for the left speaker (pos/neg) and two wires for the right speaker (pos/neg)

 

[gunz4me2 10+ year member]

Tap into the sub leads for signal. Run power and ground and you need to get remote

Or get a PAC SOEM-T and he won't need to worry about remote because it will provide him with remote turn on upon sensing an audio signal.

 

[joem1cha3l 10+ year member]

If i use the PAC SOEM-T, i still have the question. How would i connect the sub wires to this? I assume there are only two wires going to the sub?

 

[Kastlez_ 10+ year member]

Take the 4 leads from the LOC ((Left +/-)) ((Right +/-)) and (( GROUND))

there's no remote or power... just plug and play

 

[gunz4me2 10+ year member]

The PAC SOEM-T can be "bridged" to accept one input OR accept a stereo input. My wife's car has a stock DVC sub, but I just wired the SOEM-T off of one stock coil to provide signal to the aftermarket amplifier. If I can find the instructions, I'll tell you how to bridge it in a bit.

 

[joem1cha3l 10+ year member]

that would be great

 

[akheathen Premium Member]

...... i just used a regular old loc on the sub wires, and tapped into a remote wire coming out of the bose deck......

 

[dragonrage 10+ year member]

I think you'd be better off using a summing interface so that you can control what goes to the speakers and what goes to the subwoofer.

 

[akheathen Premium Member]

what amp anyways?

 

[Canaan 10+ year member]

Top the stock sub output + and - w/ the LOC + and -.

Both LOC + on the stock +. Both LOC - on the stock -.

Don't worry about the LOC ground, just insulate it.

Also, what vehicle?

I will help you find a Rap/ACC wire.

 

[joem1cha3l 10+ year member]

2007 Nissan 350 Z Touring w/ Bose No Navi. Also, ill be running a JBL 1200.1 GTO Series

 

[Philth 10+ year member]

Don't worry about the LOC ground, just insulate it.

What do you mean by this?