- Thread Starter
- #16
Normal cuts are fine, but the 45's are a ***** with MDF. It's a pretty decent $40 Craftsman carbide blade.
When doing the 45's you're cutting around 1 1/2" of material and it's probably the motor more than the blade as it's a pretty small table saw.
I noticed a big diff when doing the 45's using the Trupan as it just cut much easier.
When doing the 45's you're cutting around 1 1/2" of material and it's probably the motor more than the blade as it's a pretty small table saw.
I noticed a big diff when doing the 45's using the Trupan as it just cut much easier.