is this the same motor you were running low on oil and it was making noises when turning?
transmission wont engage
- Thread starter DarkKnightSM
- Start date
- Replies 20
- Views 4K
-
11Participant count
-
Participant list
dragon.breath 10+ year member
Senior VIP Member
Popwarhomie 5,000+ posts
Team Lethal Pressure
Firewalker
CarAudio.com VIP
Bobbytwonames 5,000+ posts
Trigger Man!
I'm sitting on the edge of my seat. Did he get it fixed or not? Somebody please contact this guy. I hate stories that end like that. We need the final chapter, no cliffhangers.
Activity
No one is currently typing a reply...
Similar threads
I suspect it's an ignition problem rather than a transmission problem.
Start with the basics: plugs, wires, coils, check engine codes.
Does the...
- Started by bananapehl777
- Wiring, Electrical & Installation
Twist both grounds together. Good call on checking power with a multimeter. I assume you have pulled out and re-inserted the fuses, so as a quick...
- Started by littlepoppa
- Head Units
You could run that sub on a 4 channel amp and have 2 channels left for amping front speakers. I just put a small system in my brothers car with a...
- Started by Swole
- Wiring, Electrical & Installation 2
That's the dd1
The dd1+ has only 4
tracks.
I have the dd1+ , just got home. I think the dd1 has all those other tracks. Diff tool. So it says...
- Started by sounds_explicit
- General Car Audio
Id remove it at this point and bench test it on 12v
- Started by craftsman82
- General Car Audio
About this thread
- Start date
- Participants
- Who Replied
- Replies
- 20
- Views
- 3,975
- Last reply date
- Last reply from
- Bobbytwonames
Latest topics
-
Jeep center console sub install issues.
- Started by vlusardi
- Replies: 1
-
-
-
-
Help With Kenwood DDX9907XR / DMX907S - Kenwood Technical Support Can't Help
- Started by fadetoblack73
- Replies: 5