to much or not enough power

[cm38]

been trying to put together a modest system for my work truck so I bough a kenwood kac-7205 and an alpine swr 1023d I have it bridged and set up with a 4ohm load so from what I get it should be at 500w rms the sub is in a just under 1.0cf sealed box so at this point I just need to figure out how to adjust everything does this set up look like it will work or am I going in the wrong direction and is this amp to weak for the sub? oh ya new here so whats up from WA,

Click to read more...

 

[mast240 10+ year member]

it should work fine... i'm not sure what you need help on exactly tho?? tuning? gains? staging??

 

[cm38]

well im not completley sure on how to set the gain

 

[Kangaroux 5,000+ posts]

There is a sticky in the electrical section on how to set it. You'll need a 50Hz test tone and a digital multimeter