Subwoofer wiring help - 3 dvc subs 4ohm

  • 2
    Participant count
  • Participants list

customgtp

CarAudio.com Newbie
3
0
USA
Hi. Signed up because I'm going crazy. I've done single, dual, and 4 subs before. Never 3 subs and it's been awhile for me too.

I have 3 4ohm subs that I'm trying to wire together and bridge on an amplifier that's 2ohm stable. Guessing it would be a 3ohm or 2.6/2.7ohm from what I've seen... Confused.

Right now I have each dvc subwoofer in series. Would make it 3/8s right? And paralleled all together that would make 8 and 8 is 4ohm on 2 subs... then that 4ohm combo to the last sub series in 8ohm to 6ohm right?? Then bridged would be around 3ohm?

Or am I paralleling them each... 4ohm to 4ohm is 2ohm each speakers then series... (math) first two subs 2ohm to 2ohm series is 4ohm... Series to the last 2ohm is 6ohm?? Then bridged would be 3ohm?

Please help or direct me 🙏
 

Attachments

  • Screenshot_20201230-114051.png
    Screenshot_20201230-114051.png
    212.1 KB · Views: 158
  • Screenshot_20201230-114028.png
    Screenshot_20201230-114028.png
    212.6 KB · Views: 146
I'm assuming these are right but just making sure these diagrams aren't considering half the ohm load due to bridged or mono amp. I don't want to go below 2ohm.
 

Attachments

  • Screenshot_20201230-125720.png
    Screenshot_20201230-125720.png
    159 KB · Views: 137
Okay... Thank you! But if I'm trying to bridge a 2 channel 2ohm stable amplifier?

Then you'd want to run the 6 ohm setup--> series/series @ 6 ohms. 2 channels that will run at 2 ohms by themselves usually only run 4 ohms bridged (as 1 channel). I would really recommend getting a mono block or just rethinking your system entirely.
 
Activity
No one is currently typing a reply...
Old Thread: Please note, there have been no replies in this thread for over 3 years!
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.

Similar threads

In a case like In a case like yours I would rather recommend tactile transducers. They are like woofers without the cone section that are...
7
688
problem was the LOC burnt out when I had touched cables. got a new LOC and now all is working. have to get the gain right, lights flickering with...
11
2K
Follow the wiring diagram provided https://euphoriacaraudio.com/product/ewx6neo/#wiring
3
1K
No. Those are speaker level inputs from the subwoofer. Lower frequencies should go to the subwoofer. The other front and rear speakers carry a...
10
1K

About this thread

customgtp

CarAudio.com Newbie
Thread starter
customgtp
Joined
Location
USA
Start date
Participants
Who Replied
Replies
4
Views
2,043
Last reply date
Last reply from
Buck
1000006564.jpg

Mr FaceCaser

    Mar 28, 2024
  • 0
  • 0
1000006569.jpg

Mr FaceCaser

    Mar 28, 2024
  • 0
  • 0

Latest topics

Top