stupid question

[808BMW]

0 gauge cutters.

Barely cut into the sheath and pull the cover off.

Same thing on 0 gauge.

And to crimp 0 gauge you use a hammer and an anvil if you can't lay it on concrete

Bingo!

Last time I bought 0 gauge the guy at the welding store was like "Dang, this stuff is horrible to work with, it take like 20 tries to cut it!"

I laughed and told him with my cutter at home I can cut 0 gauge 1 handed.

And I hammer my terminals on the concrete, sometimes with a chisel to kinda notch the terminal

 

[infamous_e46 5,000+ posts]

or just hire a hooker to **** the piece of plastic off of the wire........desired length of course

 

[fwb_1234 10+ year member]

or just hire a hooker to **** the piece of plastic off of the wire........desired length of course

That's legit right there. Good call.

 

[Ed Lester 10+ year member]

Chuck Norris strips my wire.

He uses his breath.

 

[quins90lac 10+ year member]

any thing over 8 gauge i break out the rotary tool with a reinforced cut off wheal .goes right through it like a hot knife through butter .i never crimp either i solder it works better .just fill the terminal with solider put a torch to it and melt the solder .then when its all liquid solder put the wire in .if you cut back the coating to where it touches the top of the terminal cup the heat will melt it a little giving you a water tight seal .also not all solder is the same so don't use pluming solder get the electrical solder so don't believe ppl who tell you solder is solder its all the same cause it aint

 

[Sunfire01 10+ year member]

scissors...before my mom yells at me.