speakers cut out

[ballenm04 10+ year member]

I need as much help as i can get from you guys. I have taken my boss' 2006 mustang and installed a system into it. he originally had the shaker 500 system in it. He made an LCD monitor for it and also a carputer for it. We bypassed all the factory system. I replaced the component speakers with some pioneer 3-ways. And they are hooked to a Pioneer 250w amp. The Subs are the factory shaker subs. (8" DVC) All that I did there was hook them up at 2ohm and ran them off of a 140w Pioneer amp. Both amps are being run off of a Power Akoustic 2.0F capacitor. The carputer is being run straight off of battery power.

Now for the question. When the subs actually get a decently strong signal the bass goes out for a short period of time then comes back on. What i think is that the amp is going into protection but I cannot figure out why. All of my gain and eq settings are normal. Please help me out!!!!!!!!!!

Click to read more...

 

[johnecon2001 5,000+ posts]

One post was all you needed.

http://www.caraudio.com/forum/showthread.php?t=194899

 

[ramos 5,000+ posts]

Are your subs wired 2ohm mono ? Can the pioneer handle a 2ohm mono load ? //content.invisioncic.com/y282845/emoticons/smile.gif.1ebc41e1811405b213edfc4622c41e27.gif

 

[ballenm04 10+ year member]

sorry about this second thread, i tried to post it and it didn't show then I tried again and they both showed. Please go to http://www.caraudio.com/forum/showthread.php?t=194899