Sound Deadening

I was wondering if sound deadening is worth the money. If so, where can I get some for a 1999 4runner and where do I apply it?
get your system in, play it full blast, narrow down the problem areas and buy the amount needed. You mainly only want to use it on big flat areas that can vibrate/flex to the point where it makes noise. You put CLD/dynamat/deadener matts on to reduce vibration and lower resonant frequencies. Less flex = less energy loss = louder. Not by a whole lot but its noticeable. You dont want to just cover up every nook and cranny, thats a waste of money. However if you plan on doing the whole car, look up stinger expert roadkill 36 square feet pack under 100 bucks and its thick and sticks pretty well.

Most other rattle problems, you should use weather strip foam, expanding foam aka great stuff(red can) and closed cell foam. Its to decouple(pad the surfaces, keep em from vibrating against eachother).

 
Activity
No one is currently typing a reply...
Old Thread: Please note, there have been no replies in this thread for over 3 years!
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.

About this thread

Savackz

CarAudio.com Elite
Thread starter
Savackz
Joined
Location
GA
Start date
Participants
Who Replied
Replies
5
Views
901
Last reply date
Last reply from
garychurch84
IMG_0710.png

michigan born

    May 14, 2026
  • 0
  • 0
IMG_0709.png

michigan born

    May 14, 2026
  • 0
  • 0

New threads

Top