SAE-1000D WIRING HELP please

[ONE15ISALLINEED 10+ year member]

witch rca input is black and white? they all look the exact same. and what speaker terminals do i wire 1 sub to for a mono connection? it dont really state this in the manual. thanks

Click to read more...

 

[ONE15ISALLINEED 10+ year member]

anyone???

 

[jbizzle 5,000+ posts]

Put the rcas in "Input"

Use any of the 4 terminals you want, its a mono amp, it doesn't matter.

 

[dbeez 5,000+ posts]

^^^ like he knows^^^

what you need to do is Put the rcas in "Input"

Use any of the 4 terminals you want, its a mono amp, it doesn't matter.

 

[ONE15ISALLINEED 10+ year member]

thanks for the replies. i know i plug the rcas in input, but i didnt know if i just plug the cables into either or input because there not marked red or black like other common amps. and also far as the speaker wire goes,do i just run the negative to one side of the terminals then the positive to the positive on the other set of terminals?

 

[modskwod 10+ year member]

Don't worry about the red/white or white/black, just plug them in. It doesn't matter much in sub amps as far as I know. And CLICK HERE it's on page 5.

 

[ONE15ISALLINEED 10+ year member]

see the thing is, under where it says simgle amp and sub connection. it shows positive and negative from the sub running to seperate sides of the terminals, but each wire is ran to the +. do they just mean in general run the negative and positive to each set of terminals? thats where i stand at right now, i dont wanna mess the amp up. i have the sub wired at 1ohm. right now i only have the wire ran to one set and its not as near as loud as my alpine was, granted its currently wired at 4ohms and its only rated 300 at 4ohms when my sub does 750rms-1500peak

 

[ONE15ISALLINEED 10+ year member]

well i just did it the typical way with the speaker wires, big difference and its wired at 1 ohm. still tryna get the settings right. i think i got the amp on blast and its clipping. my unit goes to 62 and im hearing loud and heavy bass at about 40 and no significant change from there and up. i could always turn my unit up to 60 without clipping the sub, would the low pass filter cause this? what should subsonic be on?