Ring terminals...how do i use em'??

[loopkiller 10+ year member]

Get a drill bit and hammer it into the terminal with the wire in. Then finish off by just hammering like crazy.

I am pretty sure that a center punch would be a much better choice than a drill bit. Drill bits are not engineered to withstand hammering.

 

[SSS 18734 5,000+ posts]

Do what I do and just bite down on them.

 

[99grandprixGT 5,000+ posts]

hammer FTW just watch your fingers:crap:

 

[Ignatowski 5,000+ posts]

I used to do this, but had one slip. now I crimp while solder

I did my entire race car main feed wire(1/0) this way

and the only way they can slip out is if the person doesnt get the wire in

deep enough...I tested the strenth and I could not pull it apart

and my race car vibrates like JennaJamasons vibrator