Right speaker pops and jvc deck says unit miswiring check wiring then reset?

[TylerMcfadyen]

i installed my deck about a week ago to my 2008 toyota tundra using a wire harness and it worked fine for about a week i have 2 10 " ken wood subs and a 800 watt amp hooked up to it and and today the sound quit coming out of the speakers but the subs were still going. so i turned off the deck and turned it back on and it says unit miswiring check wiring then reset so i pulled it out and checked all of the wires and they were all good from what i could see and now every time i turn on the deck my left speaker will make a popping sound and the message unit miswiring check wiring then reset comes up any suggestions on what i should try doing?. Thanks

Click to read more...

 

[rebelfromva 10+ year member]

Check the full length of the wires might be a short or the wires might be crushed somewhere

 

[TylerMcfadyen]

Check the wire of the speaker that pops?

 

[whitedragon551 5,000+ posts]

My suggestion is you should probably check wiring then reset. Probably have a wire mismatched somewhere.

 

[TylerMcfadyen]

it worked fine for a week and nothing got touched so i know its not a mismatched wire

 

[murph 10+ year member]

loose or unconnected wire than.

 

[TylerMcfadyen]

wires are all soldered and heat shrunk checked them all today and they were all good

 

[CrossoverOre 10+ year member]

check ohm load of left speaker. Might be bad. If speaker has been replaced might have short issue at speaker.