RF BD1001 specs?

[JeepSound 10+ year member]

Anyone have the specs on the RF BD1001?

Specifically what it will do at 2 ohms?

I can't find 'em anywhere.

Click to read more...

 

[pickup1 5,000+ posts]

my older bd1000 did 1137 watts at 2 ohms.

 

[Calikid 5,000+ posts]

not sure but underrated big time.

 

[JeepSound 10+ year member]

Thanks, I assumed it was underrated but I couldn't even find the manufacturers specs... Until I thought to check RF's site. //content.invisioncic.com/y282845/emoticons/crap.gif.7f4dd41e3e9b23fbd170a1ee6f65cecc.gif

The 1100+ is PERFECT for what I need.

Anyone know if these amps were fairly efficient, or are they pretty power hungry?

 

[9seconlives 10+ year member]

Thanks, I assumed it was underrated but I couldn't even find the manufacturers specs... Until I thought to check RF's site. //content.invisioncic.com/y282845/emoticons/crap.gif.7f4dd41e3e9b23fbd170a1ee6f65cecc.gifThe 1100+ is PERFECT for what I need.

Anyone know if these amps were fairly efficient, or are they pretty power hungry?

I have the older and newer power bd1000.1 and they both rock!!! I have had the newer one tested a couple times and the last time i did, it ran just at 1,650 wtts rms but @ 1 ohm. they are both very underrated IMO and according to the spec sheets.

 

[Evilkefz 10+ year member]

500 watts RMS x 1 at 4 ohms

1000 watts RMS x 1 at 2 ohms

Class bd technology

requires 4-gauge power and ground leads and a 100-amp fuse and fuse holder wiring and hardware not included with amplifier

selectable 50-250 Hz variable low-pass crossover, 24 dB/octave

MEHSA mounting technology increases the heat transfer from the MOSFET output devices to the heat sink, for higher power output, lower operating temperatures, and greater reliability

TOPAZ noise-killing differential inputs eliminate 80% of ground loop noise

preamp outputs for easy connection to a second amplifier

wired remote control of Punch Bass (0-18 dB centered at 45 Hz) gives you fingertip control of your bass impact

bd Sync allows you to bridge together two separate Rockford Fosgate Class bd amps (with an optional cable) to power one woofer

subsonic filter removes frequencies below 20 Hz for increased efficiency

13-1/8"W x 2-3/8"H x 9-7/8"D