Rca connection slipping

  • 2
    Participant count
  • Participant list

TDot
10+ year member

Senior VIP Member
151
0
Bronx
Every once in a while a specific rca connection I have slips off due to sub vibrations I guess. The wire is very tight and strong, but once in a while it comes off. It's most likely because it is set up vertical instead of horizontal due to space requirements. Any ideas to make it stay on?

 
Activity
No one is currently typing a reply...
Old Thread: Please note, there have been no replies in this thread for over 3 years!
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.

Similar threads

No make or model number on it? Do you have an exact picture of the rear and all its glory?
8
772
Use two sets of RCAs. One set for the Front channels and the other for Sub Output and into Rear Input on the amp. Turn off the Rear Filter on the...
5
767
Thanks a ton for your suggestion to my rather long query, I ll follow it and see how it works out. Thanks again
2
657
He'll be fine with any 4 ohm speakers, tuned properly. The focals are rated for 100 watts nominal and with the passive crossovers and power to...
6
793
Try this other test; get a 3.5mm headphone repair cable and connect it to the LC7i input. Connect that to your phone and measure. This will tell...
11
916

About this thread

TDot

10+ year member
Senior VIP Member
Thread starter
TDot
Joined
Location
Bronx
Start date
Participants
Who Replied
Replies
1
Views
516
Last reply date
Last reply from
Aygodriver1212
really.jpg

Popwarhomie

    May 25, 2024
  • 0
  • 0
Screenshot_20240524_202505_Samsung Internet.jpg

winkychevelle

    May 24, 2024
  • 0
  • 0

New threads

Top