I purchased a memphis belle mch1300. I currently have two sets of mb quart signiatures that have an rms of 90 wtts. The memphis belle is:
75w x 4 at 4 ohm
115w x 4 at 2 ohm mono
I would like to run the 115 w x 4 to each crossover. But im pretty new to this and im not sure how to do it. I know you can bridge the + from one channel to the - of the other channel and get the 115 watts that way. But then that eliminates the ability to use it as a 4 channel. How do I wire my system still using the 4 channel while still powering my components appropriately?
Also if anyone knows how the bridging module works with the 16 bridge for the memphis belle please share. I plan on running to mb quart premium 12's. Each sub has 500w rms and the amp can handle a 1 ohm load pushing 1100w rms. How do I wire it with the bridging module???? HELP...didnt know what I was getting myself into.
75w x 4 at 4 ohm
115w x 4 at 2 ohm mono
I would like to run the 115 w x 4 to each crossover. But im pretty new to this and im not sure how to do it. I know you can bridge the + from one channel to the - of the other channel and get the 115 watts that way. But then that eliminates the ability to use it as a 4 channel. How do I wire my system still using the 4 channel while still powering my components appropriately?
Also if anyone knows how the bridging module works with the 16 bridge for the memphis belle please share. I plan on running to mb quart premium 12's. Each sub has 500w rms and the amp can handle a 1 ohm load pushing 1100w rms. How do I wire it with the bridging module???? HELP...didnt know what I was getting myself into.
