Question - About how much Damplifier?

[MisterGrubbs 5,000+ posts]

After reading that thread about the Damplifier battles or whatever it was entitled, and going with my previous instincts, I'm going to be going with Damplifier Pro from SS, but the question lies - about how much of the damplifier will I need to do a solid single layer for my car? Double layer the trunk more than likely, consider it in the door panels if it doesn't make them too bulky.

2006 Chevy Cobalt SS - it's a 2 door sedan.

Any Ideas, roughly?

Click to read more...

 

[MisterGrubbs 5,000+ posts]

WTF, someone respond - even if it's with how much it took to do your car

 

[Ayrton 10+ year member]

100 sf will knock it out and you will have some left over. The Cobalt is about the same size as my car (WRX STi) and that is what I am ordering.

 

[Shelbrain 10+ year member]

I used 100 square feet and it was enough to do the trunk (minus the lid) and the cabin floor. I ordered another 50 sq feet to do the doors and roof.

 

[Anthony Collova 10+ year member]

to fully treat your colbalt the way you want to I would suggest between 80 and 120 feet. To save money, go with 80 Damplifier Pro and 40 damplifier.

This will do every metal panel in your car with Pro on the more vulnerable ares, damplifier on the less important. and if you can double up on the soft spots like trunk lid and rear deck...

Hope that helps

ANT

 

[MisterGrubbs 5,000+ posts]

I appreciate it Ant

I was told a few mins ago to pick up 150 ft foot

And he was telling me that would do the two doors and my trunk plus the lid 2x over *shrugs *

Think that's a bit outrageous?