Protection mode

[Da64u 10+ year member]

how do i kno if the ohm's are too low for the amp i dont know how to find the final load..?

 

[skadude016 5,000+ posts]

get a dmm and measure what ohm the amp is seeing. if you have a 2 ohm stable amp and say you are running it around 2ohms or lower and your pushing the amp to hard that is probably your problem

 

[Stel 10+ year member]

Assuming you have each speaker on it's own channel your ohm load on the amp should be ok. The 6x9's are 4ohms each and the 5 1/4's are 3.6 ohm each. Your amp is 2 ohm stable on each channel.

Though if the amp is bridged (2 channels combined powering 1 load) it's only 4 ohm stable.

 

[audioarsonal 10+ year member]

what is the voltage at the amp on the remote wire?does it drop below 12 volts when the problem occurs?put a volt meter on the amp on the power wire and check that then do the remote wire.you may need to run a relay.

 

[Da64u 10+ year member]

k il buy one and see wats upp