problems with car door speaker

so i got my door replaced today after someone hit and run my passenger side and upon getting my car back i realized that the door speaker on the new door (they transferred the panel to the new door) is now working at about 1/2 or 1/3 power when the door is OPEN and upon closing the door it stops working completely... any ideas of how i can fix this????

 
to be more clear, i can't find anything online about what exactly i would have to do to to fix the apparently broken connection once i take the door panel off.. it's a 95 accord ex...anyone have any xp with such a thing?

 
to be more clear, i can't find anything online about what exactly i would have to do to to fix the apparently broken connection once i take the door panel off.. it's a 95 accord ex...anyone have any xp with such a thing?
just run a new wire from the deck to the speaker , not that hard

 
@01limited-even when the door is open (even though the speaker does have output at this point) the speaker is only playing at about 1/3 volume and i know it isn't blown or anything.

@mylows10-any idea of where i could find a video or website that would explain/show me how to run a wire from the deck to the speaker as you speak of? i didn't install the speakers so my understanding of the insides of my car and which wires are which is almost nonexistent. i tried looking everywhere for a description of how to install door speakers on my car and couldn't find anything for the model (94-97)

 
Activity
No one is currently typing a reply...
Old Thread: Please note, there have been no replies in this thread for over 3 years!
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.

Similar threads

How old is the unit? My Pioneer died last month (manufacture date April 2021). Apparently they had component supply problems after Covid and...
3
765
I suspect it's an ignition problem rather than a transmission problem. Start with the basics: plugs, wires, coils, check engine codes. Does the...
4
816
Will you post a picture if the LC2i as it is wired. How did you set the output gains of the LC2i? What is the max voltage gain input on the amplifier?
1
1K
I feel like its a bad set(Low tier set) of RCAs myself. I use Stinger Zero Noise and 4000-8000 series without any issues. Dayton makes a nice set...
6
1K

About this thread

Thread starter
blackpanda1992
Joined
Location
salisbury MD
Start date
Participants
Who Replied
Replies
10
Views
972
Last reply date
Last reply from
blackpanda1992
Screenshot_20240518-030709~2.png

1aespinoza

    May 18, 2024
  • 0
  • 0
1000007975.jpg

Mr FaceCaser

    May 16, 2024
  • 0
  • 0

New threads

Top