problems with car door speaker

so i got my door replaced today after someone hit and run my passenger side and upon getting my car back i realized that the door speaker on the new door (they transferred the panel to the new door) is now working at about 1/2 or 1/3 power when the door is OPEN and upon closing the door it stops working completely... any ideas of how i can fix this????

 
to be more clear, i can't find anything online about what exactly i would have to do to to fix the apparently broken connection once i take the door panel off.. it's a 95 accord ex...anyone have any xp with such a thing?

 
to be more clear, i can't find anything online about what exactly i would have to do to to fix the apparently broken connection once i take the door panel off.. it's a 95 accord ex...anyone have any xp with such a thing?
just run a new wire from the deck to the speaker , not that hard

 
@01limited-even when the door is open (even though the speaker does have output at this point) the speaker is only playing at about 1/3 volume and i know it isn't blown or anything.

@mylows10-any idea of where i could find a video or website that would explain/show me how to run a wire from the deck to the speaker as you speak of? i didn't install the speakers so my understanding of the insides of my car and which wires are which is almost nonexistent. i tried looking everywhere for a description of how to install door speakers on my car and couldn't find anything for the model (94-97)

 
Activity
No one is currently typing a reply...
Old Thread: Please note, there have been no replies in this thread for over 3 years!
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.

Similar threads

How old is the unit? My Pioneer died last month (manufacture date April 2021). Apparently they had component supply problems after Covid and...
3
759
I suspect it's an ignition problem rather than a transmission problem. Start with the basics: plugs, wires, coils, check engine codes. Does the...
4
811
Will you post a picture if the LC2i as it is wired. How did you set the output gains of the LC2i? What is the max voltage gain input on the amplifier?
1
1K
I feel like its a bad set(Low tier set) of RCAs myself. I use Stinger Zero Noise and 4000-8000 series without any issues. Dayton makes a nice set...
6
1K

About this thread

Thread starter
blackpanda1992
Joined
Location
salisbury MD
Start date
Participants
Who Replied
Replies
10
Views
971
Last reply date
Last reply from
blackpanda1992
1000007975.jpg

Mr FaceCaser

    May 16, 2024
  • 0
  • 0
1000007974.jpg

Mr FaceCaser

    May 16, 2024
  • 0
  • 0

New threads

Top