!!!Post Ur Dream Subs And Installs!!!

[Brian_smith06 10+ year member]

hmm pretty much happy with my setup but wouldnt mind adding 15" idmax's //content.invisioncic.com/y282845/emoticons/wink.gif.608e3ea05f1a9f98611af0861652f8fb.gif

 

[p71vickin 10+ year member]

you guys forgot about the funky pups in a t-line

 

[Rich B 5,000+ posts]

Adire Audio Parthenon - Revisiting the Ultimate Subwoofer

Here are the Thiele/Small parameters of the Parthenon that was used at CES 2004.

Fs: 11 Hz

Qms: 19.4

Qes: 0.73

Qts: 0.70

Vas: 4560L

Sd: 3716 cm^2 (24" square)

Xmax: 72mm one way BL linear

Xmech: 140mm rearward one way

SPL: 91 dB @ 1W, 1m

Impedance: quad 4 Ohm voice coil

Cms: 0.24 mm/N

BL: 30.5 N/A

Re: 11.2 Ohms (all voice coils in series)

Mms: 880 grams

Vd: 53 liters

Pmax: 2000W total

Adire Audio Parthenon - Revisiting the Ultimate Subwoofer [audiojunkies]

 

[grimm 10+ year member]

as a dream setup i'd have 4 mtx 24" jackhammers with a warhorse on each in a '79 ford f-150 short box, and i'd make the entire rear-end into the enclosure.

 

[hatedonmostly 5,000+ posts]

as a dream setup i'd have 4 mtx 24" jackhammers with a warhorse on each in a '79 ford f-150 short box, and i'd make the entire rear-end into the enclosure.

lol

 

[grimm 10+ year member]

you gotta admit 40,000 watts rms chillin a few feet behind you would be orgasmic and quite possibly fatal. at least i'd die happy so it's totally worth it

 

[JordyO 10+ year member]

Have one... //content.invisioncic.com/y282845/emoticons/biggrin.gif.d71a5d36fcbab170f2364c9f2e3946cb.gif

i've had it for about 6-8 years and STILL haven't hooked it up to anything... all my cash has been going to my SPL car //content.invisioncic.com/y282845/emoticons/frown.gif.a3531fa0534503350665a1e957861287.gif

As for my dream sub.... 12" Warden or DDZ...

Basically something SPL oriented with NEO //content.invisioncic.com/y282845/emoticons/biggrin.gif.d71a5d36fcbab170f2364c9f2e3946cb.gif

 

[misfit138 5,000+ posts]

Have one... //content.invisioncic.com/y282845/emoticons/biggrin.gif.d71a5d36fcbab170f2364c9f2e3946cb.gif
i've had it for about 6-8 years and STILL haven't hooked it up to anything... all my cash has been going to my SPL car //content.invisioncic.com/y282845/emoticons/frown.gif.a3531fa0534503350665a1e957861287.gif

trade it to me.

 

[thericanballer 10+ year member]

id like to have lvl 5s, 6s, wardens, and overall the lms ultra

 

[Side Show 10+ year member]

critical mass ul12

 

[Louisiana_CRX 5,000+ posts]

critical mass ul12

I have two //content.invisioncic.com/y282845/emoticons/smile.gif.1ebc41e1811405b213edfc4622c41e27.gif check out my Saleen SQ build for upcoming pics

 

[Side Show 10+ year member]

bragger...... lol how much they set you back? i've been searching for one in australia for about 2 years

 

[Louisiana_CRX 5,000+ posts]

Thy wern't cheap...my pair are very rare svc UL12's this was a $350 option...mine have a single 1.5 vc per sub.....I had 5 UL 12's at one time but down to my last two...I have the very rare 10" Critical Mass proto type...but its not neo....I posteda pic of it on the previous page....

 

[Side Show 10+ year member]

yeah... i'd like to hear a 10inch mass, i'm running a 9510g atm, i'll just keep searching for one to pop up in aus..... dam americans get all the good shit

 

[hatedonmostly 5,000+ posts]

If I could have anything right now...it would either four 12" or two 15" Xcons tuned to 30 Hz on two Crescendo 3kWs...in a blowthrough in my single cab truck. Would be killer. //content.invisioncic.com/y282845/emoticons/biggrin.gif.d71a5d36fcbab170f2364c9f2e3946cb.gif