- Thread Starter
- #16
would there be an audible difference between 2 4 inch ports and 2 3 inch ports?
Activity
No one is currently typing a reply...
Similar threads
I'm trying to do 4 18 inch resilient sound platinums in a cpillar flat wall .4 to 5 cubes per was told they like 12 to 16 inches per cube . I have...
- Started by Bass so loud it HZ
- Enclosure Design & Construction
Personally I'd likely go slot ported with the low tuned side of the box and aero on the high tuned side. 6th orders are just big by design
- Started by 0kriz
- Enclosure Design & Construction
Yep. Point A. The last 3/4 of an inch on the exit end of the port won’t count in the displacement though. Take 3/4 off your length. You also have...
- Started by K5BEAST
- Enclosure Design & Construction
Yeah, saw that too, was like ??? wtf! They do know there stuff, I usually just roll with it!
- Started by Justin Salaro
- Subwoofers
You could try to make the port longer, but there might be other reasons with the box won't extend lower, or even the sub. You'd have to reverse...
- Started by Manu
- Enclosure Design & Construction
About this thread
New threads
-
Has anyone used DataSat Amplifiers?I have a DataSat home theater system in my media room and I...- Started by Steve IZZI
- Replies: 2
-
I need Help picking the right amplifierAny recommendations for a 5 channel amp that has a 4 ohm f/r...- Started by Zach H
- Replies: 9
-
Advice: will I have enough high frequency quality / volume?I am planning out a system for my ‘04 Ram 1500 with the...- Started by Adam LaFountain
- Replies: 8
-
RCA output questionMy son is wanting to add a 4-channel amp to power his door...
- Started by RGKeller
- Replies: 8
-
Need Help with 4 Channel amp's sound qualtiy diminishing at higher volumesHello Everybody, Due to an incorrect install from a local...
- Started by Speedyed
- Replies: 6