Please Help with EQ problem

  • 2
    Participant count
  • Participant list
Ok i installed my EQ(Clarion EQS560) to my deck(Clarion HX-d10) and everything works but there is a low crackling kind of noise that doesnt get louder with volume but always stays the same. I disconnected the harness from the EQ to see if that could be the problem but it still was making the crackling noise. With no power to the EQ but the deck on, it was still making the noise. What could be causing this problem? Its not the amps because everything else was working fine before i installed the EQ. If anyone can help it would be appreciated. Thanks.

 
Activity
No one is currently typing a reply...
Old Thread: Please note, there have been no replies in this thread for over 3 years!
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.

Similar threads

I think you're gonna have to get good with fiberglass or something, or find someone with a 3d laser scanner that can 3d print or mold you some...
7
1K
Is this a blue or blue/white wire from the Kenwood? The ACC wire is red and although that should turn on the amp, it is not the prefered wiring...
1
842
The sound deadening is going to be more about preventing vibration from metal surfaces and adding unwanted noise. Does it have the JBL system...
1
842
It's called the K.I.S.S. preciniple ("Keep it simple, stupid!")... Takes the guesswork out of parallel/series wiring.
2
1K
As for which signal to use, I tried all combinations and getting signal from the dash and front & rear doors is the only way the system sounded...
15
2K

About this thread

freeway2222

Junior Member
Thread starter
freeway2222
Joined
Location
Sayreville, nj
Start date
Participants
Who Replied
Replies
1
Views
1,222
Last reply date
Last reply from
Corsica
IMG_0005 (5) - Copy - Copy.JPG

Dan Medina

    Jun 17, 2024
  • 0
  • 0
Screenshot 2024-05-31 182935.png

Doxquzme

    Jun 15, 2024
  • 0
  • 0

New threads

Top