Lucidnonsence
Junior Member
Quick question: I about to install one of these carplay head units in a small sports car that only has one set of component speakers. So instead of using crossovers, can i do the following:
Wire the tweets to the front output
Wire the mids/woofers to the rear outputs
wire a sub to the sub output.
The use the built in crossover abilities of the head-unit to set the crossover and attenuation.
Has anybody out there done this or set this up?
If so, what settings did they use??
Wire the tweets to the front output
Wire the mids/woofers to the rear outputs
wire a sub to the sub output.
The use the built in crossover abilities of the head-unit to set the crossover and attenuation.
Has anybody out there done this or set this up?
If so, what settings did they use??
