pics of full blowthroughs

[TnT_Sounds 10+ year member]

The ultimate sleeper project right there!

To do a walkthrough would be more of a pain IMO.. You need to essentialy build a roll cage and brace up some other stuff.

You could still do a blowthrough and make it look like Jacks sleeper truck with 6 15s in his blowthrough.

He's on SMD, check out his truck

 

[orangecounty1 10+ year member]

my car isnt exactly crappy, but my system is knockin

its not exactly a BMW either //content.invisioncic.com/y282845/emoticons/biggrin.gif.d71a5d36fcbab170f2364c9f2e3946cb.gif

system is knockin, ill give you that.

 

[orangecounty1 10+ year member]

The ultimate sleeper project right there!
To do a walkthrough would be more of a pain IMO.. You need to essentialy build a roll cage and brace up some other stuff.

You could still do a blowthrough and make it look like Jacks sleeper truck with 6 15s in his blowthrough.

He's on SMD, check out his truck

check ur PMs

 

[traksta15 10+ year member]

im so debating on doing a blow through.......can you just weld it back up if you decide to go back to stock?

 

[TnT_Sounds 10+ year member]

im so debating on doing a blow through.......can you just weld it back up if you decide to go back to stock?

Of course...

Save the pieces you cut out or just when your needing to fill the hole and want to sell the truck just either weld the pieces back in or use panel bond.

Panel bond is what they use on cars straight fromt the factory in the trunk and even where they put the bottom of the bed together on trucks.. Its tough stuff.