old school lanzar optidrive 160q

  • Thread starter tmcn69
  • Replies 0
  • Views 3K

tmcn69

Junior Member
Has anyone had experience with the older lanzar optidrives? I heard they were made by zed audio, but am not sure. Here are the specs for the 160Q. I'm looking mainly for sq. Would you buy???

Model: OPTI 160Q Four Channel

Power at 12 Volts:

Four Channel RMS (peak) @ 4 OHMS/CH: 40W (70W)

Two Channel Bridged RMS (peak) @ 4 OHMS 160W x 2 (260W x 2)

Min to max voltage requirements 9 to 16 VDC

THD at Rated power 4 OHMS 0.01%

Frequency Respon 8Hz to 80KHZ +-/-1DB

Signal to noise ratio >103 DB

Damping factor >500 to 1 at 20hz

Slew Rate 40V/Micro sec

Idle Current Less than 2a

Input impendance 20k OHM

Input Sensitivity 200mV to 6V

 
Activity
No one is currently typing a reply...
Old Thread: Please note, there have been no replies in this thread for over 3 years!
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.

About this thread

tmcn69

Junior Member
Thread starter
tmcn69
Joined
Location
midwest
Start date
Participants
Who Replied
Replies
0
Views
2,805
Last reply date
Last reply from
tmcn69
IMG_20260516_193114554_HDR.jpg

sherbanater

    May 16, 2026
  • 0
  • 0
IMG_20260516_192955471_HDR.jpg

sherbanater

    May 16, 2026
  • 0
  • 0

New threads

Top