Not going to be needing this stuff any longer. 2 18" Earthquake Balls, old school in great shape. They are still in my wall so I will get better pics of them. I have been feeding the pair about 2k taking it just fine. Sound pretty damn good also. I will take $200 shipped for the pair. I will not break these up.
Next I have 2 RF Power HX2 motors, both are in great condition. Only issue is one needs mounting holes retaped. David over at PSI said he could do this no problem. I was going to have David make some 4" monsters out of these but decided to go a different route. These motors will make some beastly subs indeed. I will get pics up of these also. These are all the parts that is needed to make each take 3krms daily. David at PSI can hook it up. I need $160 shipped for the pair. I will not break up.
The parts needed to make them handle 3000+w rms would be as follows for each driver:
1 - 4" 4 layer flatwound aluminum coil
3 - 8.25 x 4 spiders w/ reinforced collar
Triple sewn-on leadwires
1 - 18" heavy duty cone assembly
1 - 6" PSI dustcap
1 - 18" 6 spoke aluminum basket
1 - 18" rubber gasket
6 - mounting screws
2 - push terminals
Next I have 2 RF Power HX2 motors, both are in great condition. Only issue is one needs mounting holes retaped. David over at PSI said he could do this no problem. I was going to have David make some 4" monsters out of these but decided to go a different route. These motors will make some beastly subs indeed. I will get pics up of these also. These are all the parts that is needed to make each take 3krms daily. David at PSI can hook it up. I need $160 shipped for the pair. I will not break up.
The parts needed to make them handle 3000+w rms would be as follows for each driver:
1 - 4" 4 layer flatwound aluminum coil
3 - 8.25 x 4 spiders w/ reinforced collar
Triple sewn-on leadwires
1 - 18" heavy duty cone assembly
1 - 6" PSI dustcap
1 - 18" 6 spoke aluminum basket
1 - 18" rubber gasket
6 - mounting screws
2 - push terminals
