Hello , I hit on this site by accident and glad I did.
I am an older guy , so I might not understand some of the terminology going on here so bear with me Please.
I just purchased a new truck, and one of the first things I wanted to do was change the HU. I decided on a Kenwood DMX 760s because I've had good luck with that brand. I'm not totally new to car audio, but i'ts been a while since I've installed one , so I need some help.
My truck has a factory BU camera and on the '19s they changed to a 40 pin connector for the camera power and ground and signal. I've searched and no one makes a harness that works with that except Metra , its a 40 pin harness for a car but the pins don't exactly match. I have narrowed down the 4 camera wires from the factory harness and their position in the connector, but I don't know how to repin a connector and then where to connect the other end of the repined harness . I hope someone will help or can point me to another post.
O Yea, I also have a IData Maestro SW i need to add to the harness. Thanks
