New Member

[PaulieD]

Hello All. Looking forward to getting some good advice here. I'm getting ready to build a system in a 2017 Wrangler Unlimited. I'm leaning towards using Focal components and subs. The current plan is to use the PS 165 F3E 3 way up front and the PS 165 FE 2 way in the roll bar. I'll build a cabinet for two P25FE 10" subs to mount behind the back seat. I can't decide on which amps to use. I already have an Alpine iLX-W650 HU installed. I've also installed sound deadening material to the hardtop(BoomMat), doors and tub(SoundSkins) and rear tub and wheel wells(DynaMat). I just can't decide on amps. Matching RMS power I would need a 75Wx4 (4 ohm) and a 600W (2 ohm) mono amp. Looking forward to comments and questions.

Click to read more...

 

[PaulieD]

This has gotten the noise level down to 70db.

 

[nauc 10+ year member]

Image Dynamics SQ1400.5 5-Channel 600W RMS SQ Series Amplifier

<ul> <li>Class-D Full Range 2-Ohm Stable 5-Channel Amplifier</li> <li>RMS Power Rating:</li> <ul> <li>4 ohms: 100 watts x 4 chan. + 300 watts x 1 chan.</li> <li>2 ohms: 200 watts x 4 chan. + 600 watts x 1 chan.</li> <li>Bridged, 4 ohms: 400 watts x

www.woofersetc.com

 

[PaulieD]

http://[URL]https://www.woofersetc....5-5-channel-600w-rms-sq-series-amplifier.html

[/URL]

Never heard of Image Dynamics. I hadn't really considered a 5CH amp. What are your thoughts about putting 100W RMS into speaker systems rated at 80 and 70W RMS?

 

[nauc 10+ year member]

Image Dynamics makes really good stuff. research it

about the wattage, just gotta set the amp gains right. heres how. the test tones are at the very bottom...

Amplifier Level Setting Guide

Note:The following article describes the Amplifier Level Setting process for most car audio amplifiers, regardless of brand. Specific target voltages for applicable JL Audio amplifiers are included...

jlaudio.zendesk.com

 

[willtruett]

I am new to the forum, I'm running two phoenix Gold sub amps, my question is I want to run the new base cube 2.0 and also the new 9 band equalizer from Phoenix, I was told from Phoenix I could split my RCA's from the base cube that puts out 9 volts too 1 amp and will split 4.5 volts to each amp which will still put out a good amount of juice, fine with that my question is I want to run the nine band equalizer also , what is the best way to run the nine band with the base cube so I can control subwoofers and all my mids, basically can The equalizer and the base cube be hooked up to the same system, I am running one amp on each subwoofer , 4 channel amp on all midwoofers and tweet, 3 amps Total,