Need help with better amp signal

  • Thread starter goualee
  • Replies 0
  • Views 443

goualee

Junior Member
I have a sundown audio amp and subwoofer that is hooked to the stock bose system on my 2012 infiniti qx56. Initially it was hooked up with a loc that was tapped to the rear stock subwoofer but anything below 35hz wasn't hitting that hard. The lower hz the less loud and sub movement. I parked next to a friend's car to plug his rca to my amp and could pretty much go as low as we tested. I purchased an audiocontrol lc2i and replaced the loc but there wasn't much difference if any besides the gain and boost on it. Will I have to get the signal elsewhere? Before the bose amp but aren't they low voltage signal? I couldn't find any wire diagram for the vehicle. I'm ok with the sound on the bose amp and speakers. Do I need to get rid of the bose amp and get a sound processor and rewire all the speakers? Need an efficient way to do this

 
Activity
No one is currently typing a reply...
Old Thread: Please note, there have been no replies in this thread for over 3 years!
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.

About this thread

goualee

Junior Member
Thread starter
goualee
Joined
Location
Hotsprings, AR
Start date
Participants
Who Replied
Replies
0
Views
443
Last reply date
Last reply from
goualee
IMG_20260516_193114554_HDR.jpg

sherbanater

    May 16, 2026
  • 0
  • 0
IMG_20260516_192955471_HDR.jpg

sherbanater

    May 16, 2026
  • 0
  • 0

New threads

Top