need help on how to wire 2 subs to 2ohms

[hondaracer48 10+ year member]

I have 2 cvr102 that are dual 2 and have 4 coils. I looked at a pic an did what I thought and want to clarify. I ran a short wire neg. To neg pos. To other pos on back of subs. I twisted 2 wires together and put them in the voice,coil 1 and ran it to the terminal on the box. Then I ran both subs to the amp and tied positive from both subs d hooked it up an neg. From both subs and hooked to neg on sub. Is this right?

Click to read more...

 

[Chevy Blazin' 10+ year member]

no that is not correct what ohm load are you trying to run the sub at to your amp

check out the link below

https://www.google.com/search?q=running+2+dvc+2+ohm+subs+to+a+2+ohm+mono+amp&tbm=isch&tbo=u&source=univ&sa=X&ei=pfl6UeLMKqrl4AOzuIGwDQ&ved=0CGgQsAQ&biw=1920&bih=955#imgrc=rxIHIm9WXPaakM%3A%3BSRf9gvX7LztvVM%3Bhttp%253A%252F%252Fm.seimg.net%252Fproduct%252Fimg%252Fsubwoofer_wiring%252F2_subs_DVC_2_ohm_mono.jpg%3Bhttp%253A%252F%252Fforums.sonicelectronix.com%252Fthreads%252F1006-Help-Me-Please-Help-Me-Please!!!%3B728%3B465

 

[hondaracer48 10+ year member]

I want 2ohms

 

[hondaracer48 10+ year member]

Ok I see how to do it, how do I get the wires from the first sub into the other side of my box? It has 2 chambers.

 

[hondaracer48 10+ year member]

someone please help im outside trying to rewire them but im stuck on how do I get the wires from one sub into the other chamber

 

[Chevy Blazin' 10+ year member]

how many terminals do you have on the sub box?

 

[hondaracer48 10+ year member]

4 all together, one negative and one pos. on both sides

 

[Chevy Blazin' 10+ year member]

You may have to drill a hole in the divider to connect to the other sub if you have only 1 speaker terminal or if you have 2 speaker terminals you can just wire it 1 + and 1 - to the terminal and the + and - from the terminal to the amp for each side

 

---------- Post added at 07:09 PM ---------- Previous post was at 07:08 PM ----------

 

4 all together, one negative and one pos. on both sides

could you post a pix of this

 

[Chevy Blazin' 10+ year member]

just pm'd you my number call or text and send me a pix of what exactly you are talking about 4

 

[hondaracer48 10+ year member]

i cant figure out how to upload a pic. so do i wire one pos. to neg with a short wire. then can i run the left over pos and neg to the box terminal. do this with both subs. then tie them together at the amp input?