My subwoofers are not working, and I don't know why. Please help!!

[robby86]

My two subwoofers have not been working since I have installed them. They have very little volume and when I put the volume up

I have pictures of the set up Subwoofers - Imgur"]here, and I need someone to tell me what i am doing wrong. I can provide more picture or anything else. Some quick info, my subs should be wired in parallel to one ohm, and are wired to this amp. I am using the factory HU, and I have the remote wire coming from the fuse box instead of the HU.

Click to read more...

 

[mylows10 5,000+ posts]

Need more info. What subs. What amp ? How are you wired to the stock deck ?

 

[robby86]

What subs. What amp ? How are you wired to the stock deck ?

I have a two Pioneer TSW310d4's as I linked above, and also a Q1-1200D Amplifier, which is also linked above. I am linked by a line out converter, which i can provide picture for if needed.

 

[caraudiochris]

First I would check the line output convertor to make sure you are getting a good signal.

Second, how are your subs wired to your amplifier?

Where is your LOC connected to?

Where is the gain set on your amp?

All new product or was it used?

Checked fuses?

 

[robby86]

First I would check the line output convertor to make sure you are getting a good signal.

I am getting headphone to RCA to test this, will post results soon.

Second, how are your subs wired to your amplifier?

In parallel like this chart.

Where is the gain set on your amp?

Currently all, the way up. Tried it with it all the way down and couldn't even get the popping sound.

All new product or was it used?

All brand new parts

Checked fuses?

All 3 fuses on the amp are not blown.

UPDATE: I used the RCA's and its just like the LOC, really quite. So I am assuming that the problem is in the amp

 

[mylows10 5,000+ posts]

Does amp power up ? Check voltage and continuity at amp

 

[robby86]

Check voltage and continuity at amp

It is telling me that it is putting out .9 ACV max and I about .6 Ohms

 

[mylows10 5,000+ posts]

Check voltage at amps power and remote

 

[robby86]

Well i just found the problem. I had it set to input slave instead of the master. Welp i just wasted 2 days for nothing.