vosschs
5,000+ posts
Banned
i had the 8002t amp for a while now then got a flame Q for christmas, it sounds very nice, i think the SQ could be a tad bit better but the spl is crazy, its only getting 400 watts rms, i would like to double that so i might get a 800 watt rms audiobahn amp that would pound, its in a ported box i think 3.25 cu ft tuned at around 41 hz
this is just a pic of the box and sub, to lazy to carpet it,
sloppy but a pic of the amp
and the start of my peel n seal procet, thats one 12 dollar roll, one layer most places i plan on getting about 2-3 more rolls for the bottom, it still rattles a lil bit, my lisence plate is the worse i think i might get like 4-5 layers around it , it took me about 15 min or less to do this, it was liek 20 degrees outside, but i heated my garage a lil bit then i had a kerosene heater and it puts out much heat so i held each piece in front of it for about 5 seconds or so, worked really good
this is just a pic of the box and sub, to lazy to carpet it,
sloppy but a pic of the amp
and the start of my peel n seal procet, thats one 12 dollar roll, one layer most places i plan on getting about 2-3 more rolls for the bottom, it still rattles a lil bit, my lisence plate is the worse i think i might get like 4-5 layers around it , it took me about 15 min or less to do this, it was liek 20 degrees outside, but i heated my garage a lil bit then i had a kerosene heater and it puts out much heat so i held each piece in front of it for about 5 seconds or so, worked really good
