my amp is messed up need info?

i have a memphis st1000d class d mono block amp the amp still turns on and plays music but after its played for a few songs nit starts drawing insane amounts of power. i took the amp apart and found some corrosion inside it looks like water got into the amp. my question is if i clean all the corrosion and whatnot off whats the chances this amp will start to work properly again?

 
If you know how and have the necessaries for cleaning electronic equipment, then I dont see a reason why you should not, also, it looks like you have no choice than to clean it.

 
i have a memphis st1000d class d mono block amp the amp still turns on and plays music but after its played for a few songs nit starts drawing insane amounts of power. i took the amp apart and found some corrosion inside it looks like water got into the amp. my question is if i clean all the corrosion and whatnot off whats the chances this amp will start to work properly again?
I recommend on getting an amp repair Tech, to take a look at it and see whats needed, and give you a quote for necessary repairs..FYI,water and electrical equipment do not mix.Hope you get it looked at,would be quite beneficial

 
Activity
No one is currently typing a reply...
Old Thread: Please note, there have been no replies in this thread for over 3 years!
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.

About this thread

sirtokesalot

Junior Member
Thread starter
sirtokesalot
Joined
Location
connecticut
Start date
Participants
Who Replied
Replies
4
Views
706
Last reply date
Last reply from
sirtokesalot
IMG_20260516_193114554_HDR.jpg

sherbanater

    May 16, 2026
  • 0
  • 0
IMG_20260516_192955471_HDR.jpg

sherbanater

    May 16, 2026
  • 0
  • 0

New threads

Top