MTX 2300x 2 12" Kicker CVR 4ohm subs...

[anderlin21 10+ year member]

What is the best wiring option for this setup?? I have it setup on 1 ohm right now but it cuts off and gets very hot. Anybody have the wattage for the amp at different ohms??

Click to read more...

 

[spl_robb 10+ year member]

What is the best wiring option for this setup?? I have it setup on 1 ohm right now but it cuts off and gets very hot. Anybody have the wattage for the amp at different ohms??

RMS Power measured at 12.5 Volts DC:

150 Watts x 2 into a 4 Ohm load with less than 0.05% THD+N

300 Watts x 2 into a 2 Ohm load with less than 0.1% THD+N

600 Watts bridged into a 4 Ohm load with less than 0.1% THD+N

Dynamic Power (IHF-202 Std) measured at 14.4 Volts DC

200 Watts x 2 into a 4 Ohm load

375 Watts x 2 into a 2 Ohm load

750 Watts bridged into a 4 Ohm load

Signal to Noise Ratio:

> or = 110dB A-Weighted

Damping Factor:

>200

Frequency Response:

20Hz-20kHz±0.25dB

 

[anderlin21 10+ year member]

Thanks for the quick reply! Right now i have the speakers wired parallel. So what i need to do to get the 4 ohm load is run the positive from sub 1 to the amp, run the negative to the positive of sub 2, and the negative of sub 2 to the amp. correct??

 

[anderlin21 10+ year member]

Is that correct? Wire the speakers parallel and the in a series to the amp?

 

[anderlin21 10+ year member]

anybody?? respond please

 

[jdawg 5,000+ posts]

I like to series them and then paralle at the amp but wither way yes it will be a 4ohm load

sell me your amp

 

[anderlin21 10+ year member]

haha i hear ya! that amp is just sick, made in 1999?? Still runnin hard! how much you looking to spend

 

[CRXBMPN 5,000+ posts]

i had one of those black mtx2300x's, it ran @ 4 ohm and did 900+watts @ 4. I blew it up and sent it in for mtx to repair and they sent it back with a birthsheet that astonished me... one of my favorite amps ever... but def def def not 1 ohm stable //content.invisioncic.com/y282845/emoticons/laugh.gif.48439b2acf2cfca21620f01e7f77d1e4.gif

 

[anderlin21 10+ year member]

Nice! Yea it pushs the kickers pretty **** hard and im just runnin it off the factory deck right now! ive never had any problems out of it