all my signal processor are Audio Control and will never be anything else,
Technically 2 line drivers and one subsonic processor,
I have the 4.1 is an EQ/linedriver pushing my mids and highs
then the Overdrive is pushing my 2 Cadence Amps for the subs
then after the Overdrive but before the Amps there is the Epicenter
WOW... This sounds like a great setup...
But I got a lot of questions....
How did you wire this... Headunit, RCAs to the Overdrive, Then RCAs to the Epicenter, then RCA Ys into your 4 inputs on Your 2 Amps? Where is your in Front or rear..
Do you think a single Over Drive would be sufficient for my 4 Sub amps?
I'm gonna have to split the output 8 ways, cause 4 amps 2 inputs each, thats 8 inputs...
I drew it out, I would need 6 RCA Y Adapters....
Like this...Comming out of the Overdrive 1 on each of the 2 outputs then 2 more on each of them, that'll give me (8) then outputs to mach up to the amps inputs..
Or I was looking at the Matrix, it has 3 pairs of outputs. I might be able to use 2 of pairs and put 2 amps on each pair, this way its fairly symetrical, I want all 4 amps to get the same levels input...
Actually, I just read the PDF again an it says
""An autosound system that utilizes multiple amplifiers will require multiple outputs.
The MATRIX provides a unique linking ability that allows two input channels to be configured to produce up to six output channels, each of which can drive up to seven amplifiers."""
OH BTW, I have an EPIcenter too... Not sure How, I'll deploy it..
Man, thanks for all your info on this.... I like to help others as much as I can, but its nice when I want more info on something and somene has some factual or real hands on comments.... Not just a ""DUDE, my Boy has Product (insert name here) and it it rocks out //content.invisioncic.com/y282845/emoticons/peace.gif.2db28b618ed8d1964ebbe2f5021d2c39.gif "....