Sold Like new JL audio 250/1 slash v2 amp

[tdblanchard13 10+ year member]

Alright, so i just bought this amp and a 12inw6v2 from a friend. after getting advice on here from you guys, im looking to buy an amp with more output for this sub. im the only other owner and this amp has seen very little use. the only scratches can be seen on the zoomed in shot where it says 250/1. Im looking for $150obo. "THIS IS NOT A v2" sorry guys my friend just corrected me, i dont know much at all about this stuff.

more photos can be added by request

Thanks //content.invisioncic.com/y282845/emoticons/smile.gif.1ebc41e1811405b213edfc4622c41e27.gif

edit: sorry for the big photos, i dont know how to reduce them //content.invisioncic.com/y282845/emoticons/frown.gif.a3531fa0534503350665a1e957861287.gif

Click to read more...

 

[tdblanchard13 10+ year member]

here is some more information...

* Class D Circuitry

* 250W RMS @ 1.5 ohms - 4 ohms

* THD at Rated Power:

* S/N Ratio: >95dB below rated power

* Frequency Response: 5 - 50,000 Hz (+0, -1dB)

* Damping Factor: >500 @ 4 ohm/50 Hz

* Input Range: switchable from 200mV-2V RMS to 800mV-8V RMS

* Differential-Balanced Input Topology: (1 pair of inputs)

* On-board Crossover: fully-variable (40-200 Hz), selectable-slope LP (12 or 24 dB per octave)

* Preamp Output: 2-channel (full-range, LP or HP)

* Bass EQ: variable boost up to 15dB

* Infrasonic Filter: defeatable 24dB/octave at 30 Hz

* Signal-Sensing Turn-On: permits operation without remote lead

* Dual mono speaker output connections: accept up to 8ga. wire

* +12V and Ground connections: accept up to 4ga. Wire

* Dimensions: 10.25"L x 9.25"W x 2.36"H

once again sorry for listing it as a v2. its not a v2!

 

[tdblanchard13 10+ year member]

bump //content.invisioncic.com/y282845/emoticons/smile.gif.1ebc41e1811405b213edfc4622c41e27.gif

 

[BreakDaLaw 10+ year member]

i have been trying to sell mine with no scratches practially brand new and havent had any luck...youd prob be better off putting it on ebay or selling to a dumbass local...just a suggestion so you aint wasting time on your part.

 

[tdblanchard13 10+ year member]

what would you think a pawn would give for this?? thanks for the hint lol

 

[tdblanchard13 10+ year member]

$100+shipping takes it. i need her to go before i resort to pawning //content.invisioncic.com/y282845/emoticons/frown.gif.a3531fa0534503350665a1e957861287.gif