L7 10 ported help

Snapper_Slapper
10+ year member

Weirdo
I've always just used manufacturer specs when I built my boxes but a few days ago I decided to try the Torres calc and some internet search for proper size/tune. I built it downfire into the spare tire area of a Scion xA with the port to the side. I did it like that because this is my sons car and I was thinking protect the sub and keep crap from falling into the port.

2013-01-05_15-43-38_212.jpg


box5.png


I went a little over my target of 1.75 cu/ft because I changed port size at the last moment and the box was already built. Also I didn't do the L port like it says but I did change the box back and forth many times to make sure the tuning was right with the straight port.

Well last night I threw it in to see how it sounded before I went any farther and I'm kinda disappointed. The deep low end bass is about what I expected but the higher bass(rock/metal music) is almost non-existent. I'm running it at about 600 rms. I couldn't really play with the x-overs and gains much last night but what I did do led me to think it's the box.

Other than running the L7(I know), where did I go wrong? Did the downfire side port kill it? Port area wrong size? Tune too low? Just to check it I ran Kickers suggested specs through the Torres and their boxes are tuned to 45-50 hz.

 
Activity
No one is currently typing a reply...
Old Thread: Please note, there have been no replies in this thread for over 3 years!
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.

About this thread

Snapper_Slapper

10+ year member
Weirdo
Thread starter
Snapper_Slapper
Joined
Location
Southern ILL
Start date
Participants
Who Replied
Replies
1
Views
854
Last reply date
Last reply from
Snapper_Slapper
IMG_0710.png

michigan born

    May 14, 2026
  • 0
  • 0
IMG_0709.png

michigan born

    May 14, 2026
  • 0
  • 0

New threads

Top