Sold KNU 1/0 runs with lugs

k_schutte
10+ year member

CarAudio.com Veteran
Rating: 100%
3 0 0
KLMX each run is 15'+ with a 100% OFC copper lug soldered on each end. I scratched the inside of the lugs with 80 grit, cleaned them with flux and then used a torch and filled each lug with solder and then pushed the wire into it. they are STRONG and not going anywhere. It is all a little dirty as it was under my Durango but no damage that I have found.

2 - blue runs

2 - white runs with red split wire loom covering most of it (about 3ft without the loom)

I would like to sell it all at once for $110 shipped. Or, I will sell two white runs and a single blue run for $80 shipped

 
Last edited by a moderator:
only time paypal makes u send a echeck is when you don't have a backup funding source like a credit card on your account. if you don't have a credit card linked to your account paypal requires you to send an echeck.

 
Activity
No one is currently typing a reply...
Old Thread: Please note, there have been no replies in this thread for over 3 years!
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.

About this thread

k_schutte

10+ year member
CarAudio.com Veteran
Thread starter
k_schutte
Joined
Location
cedar rapids, IA
Start date
Participants
Who Replied
Replies
20
Views
1,409
Last reply date
Last reply from
k_schutte
IMG_20260516_193114554_HDR.jpg

sherbanater

    May 16, 2026
  • 0
  • 0
IMG_20260516_192955471_HDR.jpg

sherbanater

    May 16, 2026
  • 0
  • 0

New threads

Top