Kicker L7 Solo Baric Flexed out...HELP!

[chak_dey 10+ year member]

yeah....and yeah...and yeah...

 

[Sleeklsc 5,000+ posts]

now that i think about it im not sure how the mtx internally bridged thingy works....but once u get the other sub wire it like this

http://www.jlaudio.com/tutorials/wiring/index.html#2dvcsp

series / parellel

then do + to speaker 1 port +

and the - to speaker 2 port -

ps thanks for makin my brain hurt!

 

[chak_dey 10+ year member]

lol....i know they were wierd at 2 ohm...cuz my friend did it before...and he wired them at 2 OHM each...so i just copied that....so it was da same....

 

[DBfan187 5,000+ posts]

You had 2 4ohm DVC subs. Each wire to 2ohms. Then connected to the amp. Your amps is internally briged. Your amp saw a 1ohm load.

2/2=1

 

[chak_dey 10+ year member]

o....really?........but they were not that loud.....or maybe they were...o shit..lol...dont know

 

[Nikuk 5,000+ posts]

o....really?........but they were not that loud.....or maybe they were...o shit..lol...dont know

either way, the that MTX gained right @ 1 ohm should put down 1500 which is not too bad for those subs (750rms)...

Even if you set the gain for 750 @ 2ohms, with that load you still would've got 1500 @ 1 ohm.

 

[davesexplorer 10+ year member]

um aren't the mtx's 1500w @ 2 ohms?

 

[DBfan187 5,000+ posts]

um aren't the mtx's 1500w @ 2 ohms?

Yes. Not 1ohm stable, unless you mod them.

 

[chak_dey 10+ year member]

****....so the whole time they were just waiting to be blowen...lol...What would be a good way to wire them, to keep them safe, because i turn them up so high sometimes. Which way be a good way, to keep the amp and subs safe?

 

[Sleeklsc 5,000+ posts]

i do no what im talkin bout somtimes^^^^#17

http://www.jlaudio.com/tutorials/wi...dex.html#2dvcsp

series / parellel

then do + to speaker 1 port +

and the - to speaker 2 port -

//content.invisioncic.com/y282845/emoticons/handclap.gif.0c301076f534e244f0460706894f19e0.gif

 

[chak_dey 10+ year member]

the link dont work......Wats a good song to break a sub in?

 

[Sleeklsc 5,000+ posts]

just go to post 17 and click that one

 

[chak_dey 10+ year member]

What ohm will that be putting out then? 4OHM or 8OHM. And that would be hard to wire it like that, from inside the box.

 

[chak_dey 10+ year member]

Which way is good to wire the subs, parallel or series wiring? for the MTX 1501D amp.

 

[Sleeklsc 5,000+ posts]

it would be a 4 ohm load...

just wire it the way the picture is...it is series/ parrlel

then

then do + to speaker 1 port +

and the - to speaker 2 port -

like i said before all the in fo u need is on post 17....ggeeeezzzz