kicker **** and problem!

[maxxguy1 10+ year member]

Radioshack sucks for electronic componants. I guarentee they won't have it. Also, DO NOT run the amp short of a mosfet. It'll change the way the electronics work and could cause a total failure.
Mosfets usually have a part number printed on them. Do NOT do what maxxguy1 said about pulling out the mosfet and the wires.

no it dose't i have had plennty of amps do this and it's never hert them yet or offected the output eather

 

[thunder9500 10+ year member]

ok i have had this happen to me alot just take of the bar that is holding down the the object that is burnt and pull that thing out make sure you just take out the one that is burnt make sure that the wire that run in to the sercut board are bulled loose and put the bar back down ion the ones that are still good and before you close it up; hook it up and see if it runs right and if ity does close it up and you are done. but after you do this just make sure you check yuor amp once in a will to make sure it dose't get to hot.

Quote:Originally Posted by pwnt by pat

That mosfet looks shot, as well as that resistor. Try replacing both, then replace anything else around the burt area.

this is the better way of doing it i would suggest doing this it is just hard finding the right size mosfet for your aplication.

http://www.webster.com