JVC KD-R530 error...miswired and needs reset.

  • 1
    Participant count
  • Participant list

greyhnd
10+ year member

Junior Member
Good day folks.

I have the above mentioned JVC receiver in my 96 Jeep Grand Cherokee. All has been good until today when I got the error about miswired and needs to be reset. I reset the deck twice, once with the engine off and once while the jeep was running. Worked for a couple minutes then the error came on again.

I haven't found any useful info about the causes online, so I'm asking here.

I'm going to check my connections at my amp and also check the grounds that I can reach. Not sure if the problem is with the door speakers, sub, or behind the HU itself in the dash. Would a faulty ground cause this error or should I be looking for shorted speaker wires and speaker connections?

Any help is greatly appreciated.

 
Activity
No one is currently typing a reply...
Old Thread: Please note, there have been no replies in this thread for over 3 years!
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.

Similar threads

Hi, if no one here is able to help you figure it out, try over at diyaudio in the car audio section, it is a more technical forum. This is one of...
1
617
Usually when you shop for a replacement harness for your model, you will find the pictures may show you in what pins your wires go to.
1
632
Yes, the power wires' colors don't match from the dash to the new harness. However, I tested them and the wire I'm treating as the constant 12v is...
9
1K
Its a Hit or Miss on FB.Market Place for buying any electronics. Pull it and wire it up at the vehicles 12v battery to see if it powers on...
2
969

About this thread

greyhnd

10+ year member
Junior Member
Thread starter
greyhnd
Joined
Location
Huntingburg, IN
Start date
Participants
Who Replied
Replies
0
Views
6,908
Last reply date
Last reply from
greyhnd
1715565471722.png

Doxquzme

    May 12, 2024
  • 0
  • 0
IMG_5880.jpeg

Brendon Jenness

    May 11, 2024
  • 0
  • 0

New threads

Top