Menu
Forum
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Gallery
New media
New comments
Search media
Members
Registered members
Current visitors
Classifieds Member Feedback
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Log in / Register
Forum
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
Log in / Join
What’s new
Search
Search titles and first posts only
Search titles only
Search titles and first posts only
Search titles only
General Car Audio
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Build Logs
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Home Audio
Off-topic Discussion
The Lounge
What's new
Search forums
Menu
Reply to thread
Forum
Car Audio Help
Wiring, Electrical & Installation
JVC KD-R530 error...miswired and needs reset.
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="greyhnd" data-source="post: 7933894" data-attributes="member: 642335"><p>Good day folks.</p><p></p><p>I have the above mentioned JVC receiver in my 96 Jeep Grand Cherokee. All has been good until today when I got the error about miswired and needs to be reset. I reset the deck twice, once with the engine off and once while the jeep was running. Worked for a couple minutes then the error came on again.</p><p></p><p>I haven't found any useful info about the causes online, so I'm asking here.</p><p></p><p>I'm going to check my connections at my amp and also check the grounds that I can reach. Not sure if the problem is with the door speakers, sub, or behind the HU itself in the dash. Would a faulty ground cause this error or should I be looking for shorted speaker wires and speaker connections?</p><p></p><p>Any help is greatly appreciated.</p></blockquote><p></p>
[QUOTE="greyhnd, post: 7933894, member: 642335"] Good day folks. I have the above mentioned JVC receiver in my 96 Jeep Grand Cherokee. All has been good until today when I got the error about miswired and needs to be reset. I reset the deck twice, once with the engine off and once while the jeep was running. Worked for a couple minutes then the error came on again. I haven't found any useful info about the causes online, so I'm asking here. I'm going to check my connections at my amp and also check the grounds that I can reach. Not sure if the problem is with the door speakers, sub, or behind the HU itself in the dash. Would a faulty ground cause this error or should I be looking for shorted speaker wires and speaker connections? Any help is greatly appreciated. [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Help
Wiring, Electrical & Installation
JVC KD-R530 error...miswired and needs reset.
Top
Menu
What's new
Forum list
