Just a quick simple question *Kx2500.1*

Yeah amp works great otherwise,the fan connections were good and im not sure if the fan even kicks in at all I havent been able to check until i can get my H/O alt installed to really play it a lil more than 5 seconds at a time lol

 
Ok So I checked the connection to the fan,When I power the amp up you can see ti spin for one split second meaning there is power going to the fan,Im guessing it only turns on when needed.So I ran the fan to where the power led used to be hooked up so the fan is always on when the amp turns on,do you guys think that will be ok since i dont use the led for the amp anyways?

 
The fan could pull quite a bit more current than an LED. I wouldn't do that without being sure the power LED output can handle whatever wattage that fan requires in a worst case scenario. the led output might not give the fan enough voltage to really get it moving well, too.

 
So I should just hook it back up like it was and hope its really doing its job? I guess I havent played it enough for it to come on,it normally doesnt even get warm because its only less than quarter way up with no bass boost of course.

 
Activity
No one is currently typing a reply...
Old Thread: Please note, there have been no replies in this thread for over 3 years!
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.

About this thread

eutechnyx

10+ year member
CarAudio.com Elite
Thread starter
eutechnyx
Joined
Location
florida
Start date
Participants
Who Replied
Replies
11
Views
725
Last reply date
Last reply from
eutechnyx
IMG_20260506_140749.jpg

74eldiablo

    May 22, 2026
  • 0
  • 0
design.jpeg

WNCTracker

    May 22, 2026
  • 0
  • 0

New threads

Top