I'll get you measurement today
*****INSERT MEASUREMENT HERE*****
So this just shows how I have the wiring ran, ITS TEMPORARY... When I strip the truck to do the matting it'll get re-routed, loomed, etc...
everything runs through under the drivers side trim panels
BLUE = Audiopipe 0 Ga
Red = Remote from HU
Golds = RCA
Black solid = MP3/CD Changer
Black Thin = Bass Remote
This is the only place of disarray in the truck, for now... All the wire exits behind the rear seat and all the extra is currently just thrown there for now
Into the amp... When I rebuild the back wall, the wood will go the complete width of the cab
it is upside down but this pic was just temporary to mock up what I would have to cut and so on...
I have to cut all bracketry off the seat... so when I fold up the bottom for whatever reason it doesnt do this
here we can see how everything hides nicely
everything runs behind the fuse panel, knee boulster and etc to the center of the truck... It's all wrapped and tied together..
The red wire in the fuse panel is the 12v to the HU since I didnt get the 80 dollar retained power module... The white wire runs into the roof for this
When its together everything is hidden
No wires seen
and the bass knobs home for now.. Its velcro'd to the bottom of the ash tray, since I dont smoke... I dont need to worry about it getting banged up opening and closing
The blue light on that little bastard is BRIIIIIIIIIGHT I almost need to be wearing sunglasses at night in order to stand it... The only ***** of it is having to reach way down there to adjust the knob so I may move it and tint the blue led to not be as bright in my eyes.
Again everything is temporary mocking up. With this truck I dont want things to look out of place, so nothing will be left "hack" looking... It'll all be cleaned up and put away to where it looks stock..
The only thing that doesnt look stock when you pop the hood is the Fuse block bolted to the fuse center. Couldn't get away with that.