Is my wiring correct at the amp bridge terminals??

[CoilBurner]

Trying to wire Two DVC 2ohm subs down to .5

Basically all the positive together, and all the negative together.

On my Audiopipe AQX3500.1 though, there is 4 terminals for inputs. 2+ and 2-

This is how I have it wired

Correct? Or is there a better way to do it? I measured the end of my wire and Im indeed getting .4ohm so its wired right. I just dont know if I plugged it into the amp correctly

Thanks for any help!

Click to read more...

 

[daboyfrumdabx 10+ year member]

Just pick a + and a - and you're fine. It's still one channel. You can use the outside, the inside, or in mix match. As long as you have one + and - you'll have issues the way you're wired. The amp just has 4 terminals for ease of installation. Rather than wire everything the way you did, you could have wired each sub to 1 ohm and hooked each one to it's own set of terminals, creating .5 at at the amp. In short, yes the picture you have is fine.

 

[CoilBurner]

Cool, I changed the wiring to like you said, each coil parelelled and its own run to each amp inputs positive

Didnt know they were linked inside, just gives me more reason to waste more 10 gauge speaker wire, more runs ftw