E Eldorado 5,000+ posts Banned 5,474 0 So Cal Feb 5, 2006 #16 k, the center pin thing needs to be soldered to the un sheilded wire the round clamp thing on the back needs to be soldered to the sheilded wires.
k, the center pin thing needs to be soldered to the un sheilded wire the round clamp thing on the back needs to be soldered to the sheilded wires.
OP Bigrick31 10+ year member Carpe Diem 3,572 0 Mid*Cal Feb 5, 2006 Thread Starter #17 so 1 insulated wire to each side of the clamp? and i dont imagine that the order of the insulated wires matter? you know i think the un insulated wire is a drain wire. gets rid of noise caused by EMF by grounding to the connector.
so 1 insulated wire to each side of the clamp? and i dont imagine that the order of the insulated wires matter? you know i think the un insulated wire is a drain wire. gets rid of noise caused by EMF by grounding to the connector.
jrz126 10+ year member Senior VIP Member 483 0 Erie, pa Feb 5, 2006 #18 how many wires do you have? The center pin is the signal, the shield is on the outside.