Installing an Alarm???

carguy6702
10+ year member

Member
how hard is it to install and alarm? i want to install one in my 2001 GMC Sierra its the base model no power windows or locks. i also want to install power locks and power windows. what tools would i need and what equipment? can anyone help on how to install? thanx

 
Here is the wiring diagram. You will need some crimps,test light,connectors,etc.

12volts red + ignition harness

Starter yellow + ignition harness

Ignition pink + ignition harness

Power Lock lt. blue + brown plug at BCM

Notes: The BCM is located behind the drivers side of the dash. The plugs on the BCM face towards the rear of the vehicle. The parking lights are in pin A5 and the headlights are in pin A11.

Power Unlock white + brown plug at BCM

Notes: The BCM is located behind the drivers side of the dash. The plugs on the BCM face towards the rear of the vehicle. The parking lights are in pin A5 and the headlights are in pin A11.

Lock Motor gray driver kick panel

Unlock Motor tan driver kick panel

Disarm Defeat tan/black passenger kick panel

Parking Lights+ brown + lt. blue plug at BCM

Notes: The BCM is located behind the drivers side of the dash. The plugs on the BCM face towards the rear of the vehicle. The parking lights are in pin A5 and the headlights are in pin A11.

Parking Lights- white - lt. blue plug at BCM

Notes: The BCM is located behind the drivers side of the dash. The plugs on the BCM face towards the rear of the vehicle. The parking lights are in pin A5 and the headlights are in pin A11.

Hazards

Turn Signal(L)

Turn Signal®

Door Trigger - BCM

Notes: The BCM is located behind the drivers side of the dash. The plugs on the BCM face towards the rear of the vehicle. The parking lights are in pin A5 and the headlights are in pin A11.

Use tan for the drivers door located in pin B4 of the purple plug, and for the passenger door it will be a orange in pin B2 in the purple plug or dk.blue/white in pin B11 of the lt.blue plug, must diode isolate these wires.

Dome Supervision

Trunk/Hatch Pin

Hood Pin

Trunk/Hatch Release

Power Sliding Door

Factory Alarm Arm

Factory Alarm Disarm lt. green - driver kick panel

Notes: Also found in the purple plug of the BCM.

Disarm No Unlock

Tachometer white ac ECM

Notes: ECM is located near the battery, down low, between the fender and the fan under the black plastic cover. On the 4.3L, the tach wire is at pin 20 in the connector labeled red. On the 4.8L, 5.3L, and 6.0L, the tach wire is located at pin 10 in the red connector.

Diesel tach wire is white at the cluster.

Horn Trigger black - brown plug at BCM

Notes: The BCM is located behind the drivers side of the dash. The plugs on the BCM face towards the rear of the vehicle. The parking lights are in pin A5 and the headlights are in pin A11.

Memory Seat 1

Memory Seat 2

Memory Seat 3

Interface Module: Category:

Immobilizer Bypass Required:

Yes Type:

Passlock II

Part #: 556LW

Alternate Part1 #: 555LW

Alternate Part2 #: DesignTech 20402

Alternate Part3 #: DesignTech 29402

Notes:

Interface Module: Category:

Door Lock Interface Required:

No Type:

N/A

Part #: N/A

Notes:

Interface Module: Category:

Combo Interface Required:

Yes Type:

Data Bus

Part #: 457GW

Notes: Can use the 457GW to bypass the Passlock II, but it will not control the door locks on this model year.

 
Activity
No one is currently typing a reply...

About this thread

carguy6702

10+ year member
Member
Thread starter
carguy6702
Joined
Location
Dallas, Tx.
Start date
Participants
Who Replied
Replies
1
Views
952
Last reply date
Last reply from
eatank
1778763859842.png

Doxquzme

    May 14, 2026
  • 0
  • 0
IMG_20260513_214311575.jpg

ThxOne

    May 13, 2026
  • 0
  • 0

New threads

Top